Page 13: 2 auxiliary sends, 3 balance, 4 pfl, 5 routing
Advertising
1
4
12 9 STE STE 10 L R L IX INS R L APE RETN R IX AUX AUX 2 1 L M R PHNS NTR M NTR M M Along the CHANNEL STRIP, controls adjust the GAIN (to get the best quality signal and avoid overload) and the FILTER and EQUALISER change the frequency response to clean up or enhance the. SPIRIT FOLIO. MONO INPUT CHANNEL Input. Soundcraft Spirit Folio 10-2 Mixing Desk Spirit Folio console brings you the expertise and support of one of the industries leading manufacturers and the results of over 20 years experience supporting some of the biggest names in the business. Built to the highest standards using quality components.
4
1
1
2
3
4
5
STEREO RETURNS
There are four Stereo Returns, which have similar controls but different routing
configurations to provide the maximum flexibility. Each Return has an
unbalanced stereo input on 3-pole A gauge (TRS) jacks. If a mono source is
to be used, plugging into the Left jack automatically feeds the signal equally to
both sides of the Return.
1 LEVEL
The LEVEL control sets the overall signal level, and enough gain is available to
match both +4dBu and -10dBV sources. Rotation clockwise increases the gain
of the input.
2 AUXILIARY SENDS
Each Return may access Aux 1 (Pre-fade) and one of the post-fade sends.
Returns A & C feed to Aux 3 and Returns B & D feed to Aux 4. The controls
should be turned fully anticlockwise when not in use.
3 BALANCE
This control sets the amount of the channel signal feeding the pairs of Groups
or Mix, allowing you to balance the source in the stereo image. When the control
is turned fully right or left you feed only that side of the signal to the destination
selected by the Routing switch (see below).
4 PFL
When the PFL (Pre-Fade-Listen) switch is pressed a mono sum of the pre-fade
signal is fed to the headphones or monitor output, replacing the selected source.
The PFL LED on the Master section illuminates to warn that the headphones, Gas-fired warm air furnace user's information manual.
monitor and right bargraph meter are now responding to the PFL/AFL selection.
5 ROUTING
This switch selects either a pair of Groups (switch released) or Mix (switch
pressed) as the destination for the Stereo Return signal after it has passed through
the BAL control. Returns A & B route to Groups 1 & 2, and Returns C & D route
to Groups 3 & 4. The left return signal feeds the odd-numbered Group or Mix
Left, while the right return signal feeds the even-numbered Group or Mix Right.
12
SPIRIT FOLIO RAC PAC
Advertising
Popular Brands
Popular manuals
Advertising
INITIAL SETTING UP
You will probably use your SPIRIT FOLIO RAC PAC with a wide range of different types of sound source, and these will
be at varying signal levels. It is important to set the GAIN of the inputs correctly to give the best performance.
Set up the individual Mono input channels as follows:
••
Plug in the chosen source (usually the MIC input for mics and the LINE input for anything else). Plug in phantom
powered mics before switching the phantom power on. Set the channel fader fully down.
••
Set the Group and Master Faders at 0 and GROUPS TO MIX pressed.
••
Select MIX to C/Room & Phones.
••
Check that SOLO MODE is released.
••
Release the channel routing switches to route to Groups 1-2
••
Provide the chosen source with a typical signal level and press the latching PFL button by the fader. The level of
signal will be shown on the right-hand Bargraph Meter (the Left meter will be switched off when the PFL button is
down).
••
Adjust the input GAIN until the meter is just reaching the amber LED (0dB) at a typical maximum source level with
a steady signal. If the source signal is rich in high-level transients (e.g. drums) a rather higher meter reading of
+6/+9 will be needed to achieve an equivalent average level. This leaves enough headroom to cope with peaks
in the signal without distortion.
Soundcraft Spirit Folio 12/2 Power Supply
••
Adjust each input channel in the same way.
••
Soundcraft Spirit Folio Notepad
If you find that you cannot set a reasonable level within the range of the GAIN control when using a MIC input
on the Mono channels, try the LINE input instead.
Stereo inputs 11-14 do not have a GAIN control, since the typical source for these inputs will be external tape machines
or effects units which have a much more predictable signal level. Set the +4/-10 switch to +4 (released) initially, and
check the input level with the PFL switch as decribed above. If the level is too low, switch to the -10 input setting.
You will now have initial settings for each of the input sources and are ready to start building a mix.
••
Connect your power amplifiers and speakers and set the gain of the amplifiers to about 70%.
••
Soundcraft Spirit Folio Sx
Move the individual channel faders gradually to the required working level, listening carefully for any hint of
feedback or overload. You may find that the input gain settings will need to be edged back slightly as the mix is
built up.
••
Listen carefully for the characteristic sound of feedback. If you cannot achieve a satisfactory input level setting
without feedback, adjust microphone and speaker positions and try again.
The AccurioPress C3080/C3070 can be equipped with a vast range of finishing options that are designed and developed for the print system and importantly supported by your local service provider, to provide trouble free operation.Long sheet printing is now enhanced to enable 1300mm long simplex and an amazing 762 long sheet auto duplex, all of which will deliver a greater print offering to clients.Professional Envelope printing has been redefined to a high speed, high quality inline system that provides another revenue stream for a print business. Konica minolta bizhub press c1070 user manual. Full coverage envelopes can act as a mini billboard to promote a multitude of activities or even to entice clients to open the envelope.
Careful microphone placement and the choice of a suitable type of microphone is important for vocals. The aim should
be to place the microphone as close as possible to the source, to cut out unwanted surrounding sounds. This allows a
lower gain setting on the mixer and helps to avoid feedback. You will also find that a well-placed microphone will not
need any appreciable equalisation.
SPIRIT FOLIO RAC PAC
5
Advertising
Popular Brands
Popular manuals